You need a tool, a tool of veins (optional), an 18 gauge wire or a frillstick, two cutters of rose petals that follows in size and fits the size you want pink, taped 20 gauge wire, gumpaste, of course, a rolling pin and a mat. A small foam pad is optional.
Some 20 gauge wire, tape and glue a cone of gumpaste pointed to it. Let dry for at least 12 hours.
With the smallest petal cutter, cut a petal. Thin the edges with a ball tool and mood and with a frillstick or, as here, a piece of floral wire 18 gauge.
Wrap tightly around the cone with glue.
Cut out two smaller petals, ball frill li and curling edges, as shown in the picture.
Wrap the cone with glue and let the petals overlap. This step is where you choose how to open your rose should be. If you leave a large gap between Cone and Petal Pink, appear very open. Wrap it tightly to look more dense. You can smooth the inside of the petals with streaks tool to get a more well-rounded.
Should look like this.
Repeat with 3 small petals. You can leave the pink dry for a few hours, now make it easier the next step.
Repeat with 5 large petals. Should look like this.
Repeat again with 5 large petals. I do this upside down on a small foam pad, it makes it easier to get clean.
And voila. Put a Cup on if you want. You can cut the wire now, or leave it in if you are doing a spray.
No comments:
Post a Comment